Pianos regularly make movers yearly list of products that are most frequently harmed. Grand pianos are specifically bothersome. Practicing the following procedures for taking apart, padding and loading grand pianos will avoid damage, lower claims expenditure, and enhance consumer satisfaction.
1) A minimum of 3 people are needed to manage a baby grand piano. If the baby grand piano requires to go up or down stairs or if a full or performance grand piano needs to be transferred, a minimum of four people are required.
2) Always complete a thorough and precise stock. It may be more effective or needed to utilize a visual inventory to adequately explain and show pre-existing damage.
3) As numerous parts are taken apart, please location all hardware in a correctly identified parts bag and after that put the parts bag in a "Components Box".
4) Remove the music rack (lyre) from its track by pulling it towards the keyboard. Wrap it in a tidy furniture pad.
5) Detach the lid by eliminating the hinge pins. Have someone wiggle the cover, holding it opposite the hinge, while a second person works the pin loose. Please beware not to damage the wood with the pliers or with the pin itself. Cover the jaws of the pliers with a little fabric to assist avoid damage to the wood if essential. Wrap the cover in a clean furnishings pad.
6) Remove the prop that holds the lid open and wrap it in a clean furniture pad. The prop has a hinge pin and is in two pieces.
7) Get rid of the pedal assembly and cover it in a clean furnishings pad. When eliminating the screws, please be careful not to drop the braces. As you deal with the piano, number the push-rods from left to right as "1", "2", and "3", by putting a piece of masking tape with the appropriate number on each rod.
8) Pad the piano by positioning a tidy rolled furnishings pad (stretch-wrap the pad to prevent it from unrolling) on the cover of the keyboard to prevent it from tumbling open while you manage the piano. Note: Please make sure that the surface of the piano is dust-free before padding it.
9) Position a piano board and connect the straps so that it is all set to get the piano. The raised brace on the piano board should be at the keyboard end of the piano.
10) Get rid of the left front leg by placing one individual beneath the piano at the left end of the keyboard. Be sure to have two individuals raising the corner of the piano while the third person removes the leg. dig this Keep in mind: Please be sure to keep in mind which legs were eliminated from which positions since some pianos have legs that are not interchangeable.
11) Location the piano on the piano board by reducing the "leg-less" end onto the board. Please be sure to lift the whole piano somewhat while completing this maneuver to avoid undue pressure on the staying, attached anchor legs as the piano tips. Raise the piano to an upright position on the board. Note: Please make sure that the soundboard is protected prior to lifting. Make certain that the piano is centered comfortably versus the brace at the end of the piano board. Note: Never leave the piano ignored. Always have at least one individual holding the piano steady at all times.
12) Eliminate the 2 staying legs and wrap them in clean furnishings pads. These legs are kept in location by a "crucial and slot" plan. To remove the leg, slide it inward toward the center of the piano till it comes out of the slot.
13) Protect the piano to the piano board by bringing completions of the straps together and fastening them. Place folded burlap pads over the furniture pads but under the straps to offer additional security to the edges of the piano. To prevent the strap near the narrow end of the piano from slipping off, tie the loose ends of the two straps together.
14) To move the piano over a flat, level surface area, tilt the piano and piano board and location a four-wheel dolly under the center of the piano board.
15) To move the piano up or down stairs, utilize the piano board as a skid. After adequately padding the stairs for protection against house damage, position the keyboard end of the piano towards the bottom of the stairs. Attach a bulge strap to the top end of the piano more info board to prevent the piano from slipping.
16) To load the piano, leave it on the piano board and location it in a tier as the first base item with the keyboard facing the wall of the preceding tier. The best location to fill the padded cover is in between the piano and the preceding tier or between the piano and the wall.
Grand pianos represent a considerable challenge, they can be moved without damage by utilizing common sense and practicing the treatments listed above.